Back To MATERIAL SAFETY DATA SHEET

MATERIAL SAFETY DATA SHEET
RAKA INC. Oleander Ave. Ft. Pierce, FL. 34982 Emergency Phone (772) 489-4070
  
PRODUCT NAME: RAKA EPOXY RESINS:   127, 900, 1500, UV Inhibited Part A,  Tabletop Resin, Superfast Resin    Effective Date:     6-1-2015
Product Code:      Raka - 127, Raka - 900, Raka - Table Top, and Raka Superfast Resin
1.     INGREDIENTS:
Reaction products of Epichlorohydrin and Bisphenol A                         CAS # 025-085-99-8              >80%
Alkyl Glycidyl Ether                                                                                CAS # 068609-97-2               <20%
Benzyl Alcohol                                                                                        CAS # 100-51 -6                    <10%
The balance of materials are trade secrets                                                CAS # Proprietary                  <5%
This document is prepared pursuant to the OSHA Hazard Communication Standard (29 CFR 1910.1200). In addition, other substances Not Hazardous per this OSHA Standard may be listed. Where proprietary ingredients are shown, the identity may be made available as provided in this standard.

2.     PHYSICAL DATA:
BOILING POINT: not applicable
VAP PRESS: not applicable
VAP DENSITY: not applicable
SOL. In WATER: none
SP. GRAVITY: 1.12-1.14 APPEARANCE: straw colored liquid

3.     FIRE AND EXPLOSION HAZARD DATA:
FLASHPOINT: 245 F
METHOD USED: PMCC FLAMMABLE LIMITS:
LFL: not applicable
UFL: not applicable EXTINGUISHING MEDIA: foam, C02, dry chemical FIRE AND EXPLOSION HAZARDS: none
FIRE FIGHTING EQUIPMENT: Wear positive pressure self-contained breathing apparatus.

4.     REACTIVITY DATA:
STABILITY: (CONDITIONS TO AVOID) Excess heating over long periods of time degrades the resin. INCOMP AT ABILITY: (SPECIFIC MATERIALS TO AVOID) Base.
HAZARDOUS DECOMPOSITION PRODUCTS: The by-products expected in incomplete prolysis or combustion of epoxy resins Are mainly phenolics, carbon monoxide, and water. The thermal decompression products of epoxy resins therefore should be treated as potentially hazardous substance. Appropriate precautions should be taken.

5.     ENVIROMENTAL AND DISPOSAL INFORMATION:
ACTION TO TAKE FOR SPILLS / LEAKS: Soak up in absorbent material and collect in suitable containers. Residual may be removed using steam or hot soapy water.
DISPOSAL METHOD: Burn in adequate incinerator or bury in an approved landfill; in accordance with local, state, and federal regulations.

6.     HEALTH HAZARD DATA:
EYE: Minor transient irritation, No corneal injury is likely.
SKIN CONTACT: May cause allergic skin reaction in susceptible individuals. Prolonged exposure not likely to cause significant skin irritation. Repeated exposure may cause skin irritation.
SKIN ABSORPTION: A single prolonged exposure is not likely to result in the material being absorbed through skin in harmful amounts. The LD50 for skin absorption in rabbits is 20,000 mg/kg.
INGESTION: Low acute oral toxicity; LD50 (rat) greater than 400 mg/kg. No hazards anticipated from ingestion incidental to industrial exposure.
INHALATION: Vapors are unlikely due to physical properties. Not a problem unless healed to high temperature.
SYSTEMIC AND OTHER EFFECTS: Except for skin sensitization, repeated exposure to low molecular weight epoxy resins of this type are not anticipated to cause any significant adverse effects. A poorly characterized sample of molecular weight epoxy resin of this type has Been reported to produce skin cancer in a highly sensitive strain of mice. However, high levels of impurity compromise the validity of manufacturing processes is not believed to be a cancer hazard to humans. Results of mutagen city tests in animals have been negative. It has been shown to be negative in some in vitro mutagen city tests and positive in others.

7.     FIRST AID:
EYES: Irrigation of the eye immediately with water for five minutes is good safety practice.
SKIN: Contact will probably cause no more than irritation. Wash off in flowing water or shower. Wash clothing before reuse. INGESTION: Remove to fresh air if effects occur. Consult medical personnel.
NOTE TO PHYSICIAN: No specific antidote. Supportive care. Treatment based on judgment of the physician in response to reactions of the patient.


8.     HANDLING PRECAUTIONS:
VENTILATION: Good room ventilation usually adequate for most operations. RESPIRATORY PROTECTION: None needed.
SKIN PROTECTION: For brief contact, no precautions other than clean body-covering clothing should be needed. Use impervious gloves when prolonged or frequently repeated contact could occur. EYE PROTECTION: Use chemical goggles.

9.     ADDITIONAL INFORMATION:
SPECIAL PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE:
Practice good caution and personnel cleanliness to avoid skin and eye contact. Avoid breathing vapors of heated material.

10.   NFPA HAZARD RATING:
STATUS ON SUBSTANCE LISTS:
The concentrations shown in this document are maximum or ceiling levels (expressed in weight %, unless otherwise specific) to be used for regulations. Trade Secrets are indicated by "TS".
FEDERAL EPA
COMPREHENSIVE ENVIRONMENTAL RESPONSE. COMPENSATION. AND LIABILITY ACT OF 1980 (CERCLAY): Requires notification of the National Response Center of release of quantities of Hazardous Substances equal to or greater than the reportable quantities (RQ's) in 40 CFR 302.4. Components present in this product at level, which could require reporting under the statute are: Chemical Name    CAS Number       % By Weight    NONE

SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF 1986 (SAR) TITLE III:
Sections 301-304 require emergency planning based on Threshold Planning Quantities (TPQ's) and release reporting based on Reportable Quantities (RQS) in 40 CFR 355. Components present in this product at level, which could require reporting under the statute are:         Chemical Name    CAS Number       % By Weight   NONE 

Sections 311-312 require products to be reviewed and applicable EPA Hazard Definitions be identified.
EPA HAZARD CLASSIFICATIONS:
Acute    Chronic   Fire       Pressure   Reactive
Hazard   Hazard   Hazard   Hazard    Hazard
No          No         No          No           No
Section 313 requires submission of annual reports of releases of toxic chemicals that appear in 40 CFR 372 (for SARA 313). This information must be included in all MSD's that are copied and distributed for this material. Components present in this product at level, which could require reporting under the statute are: Chemical Name    CAS Number       % By Weight NONE
If you are unsure if you must report more information, call the EPA Emergency Planning and Right-To-Know Hot line: 800-535-0202 or 202-479-2449.  

 TOXIC SUBSTANCES CONTROL ACT (TSCA):
The components of this product are contained on the chemical substance inventory list.

OTHER REGULATORY INFORMATION: D.O.T. Shipping Name: Not Regulated

 

The information herein is given in good faith, but no warranty expressed or implied is made.

11. LABEL ELEMENTS:
Labeling according to Regulations (EC) No 1272/2008
Hazard Pictograms:
warning
GHS07

Signal Word: WARNING
Hazard-determining components of labelling: Bisphenol A based Epoxy Resin
Hazard Statements:
H312: Harmful in contact with skin
H317: May cause an allergic skin reaction
H412: Harmful to aquatic life with long lasting effects
Precautionary Statements:
P264: Wash hands thoroughly after handling
P270: Do not eat, drink, or smoke when using this product
P271: Use only in well ventilated area
P273: Avoid release to the environment
P280: Wear Protective gloves/protective clothing/eye protection/face protection
P337+P313: If eye irritation persist: Get medical advice/attention
P370+P378: In case of fire: Use for extinction: CO2, powder, or water spray
P302+P352: If on skin: Wash with plenty of soap and water
P391 Collect spillage
P304+P235: Store in well-ventilated place. Keep cool
P501: Dispose of contents/container in accordance with local/regional/national/international regulations

TOP